Logo

Check U2608 Engine Code

U2608 Engine

When you check engine light came on code U2608 the reason should be . However your vehicle's manufacturer may have a different definition for the U2608 OBD-II Diagnostic Network (U) Trouble Code. So you should chech it on our car models.

U2608 code can be about replacing a broken oxygen sensor can eventually lead to a busted catalytic convertor which can cost upwards of $2,000. Taking your car into a shop will cost you around $200 depending on the car. However, an oxygen sensor is easy to replace on many cars and is usually detailed in the owner's manual. If you know where the sensor is, you only have to unclip the old sensor and replace it with a new one. Regardless of how you approach it, you should get this fixed right away.

U2608 Possible Solution:

In-line Ford engines, along with those of most other manufacturers, begin the numbering of cylinders at the front and proceed in numerical order toward the back. In the V-engine design, Ford follows a similar design with the number one cylinder at the front left of the engine. In the V-6 configuration, cylinder 4 is at the front right of the engine and in a V-8, cylinder number 5 is in that location. Other manufacturers sometimes use an alternating pattern in the V-engines.

U2608 Code Meaning :

U 2 6 0 8
OBD-II Diagnostic Network (U) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Fuel Temperature Sensor B Circuit Range/Performance Cold Start Injector 1 Malfunction Clutch Position Sensor Circuit Malfunction

Regarding the U2608 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U2608 OBD-II Diagnostic Network (U) Trouble Code Description

U2608 engine trouble code is about Clutch Position Sensor Circuit Malfunction.

Reason For U2608 Code

The reason of U2608 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

U2608 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.